Delfield 8100-EF Dokumentacja Pobierz pdf (Strona 13)

N8000 Series Drop-In Installation and Operation Manual

For customer service, call (800) 733-8829, (800) 733-8821, Fax (989) 773-3210, www.delﬁeld.com

Delfield

™

Hot Operation

N8600 Series hot and cold combination pans must be operated

with water in the well for proper hot operation. Fill well with a

minimum of 4” (10.2cm) of water. Place function switch in HOT

position. Turn thermostat dial to highest position and allow unit

to warm up. Then reset the thermostat to maintain the desired

temperature.

Never use anything other than plain water

in the wells or tank. Failure to observe this

warning may result in personal injury or

damage to the unit.

When operated at the highest temperature

setting, the top of the unit will become very

hot. Staff and customers using the equipment

should be informed about this.

To turn unit off, simply move the function switch to OFF position.

Drain water and allow unit to cool before cleaning or switching

to cold operation.

Cold Operation

Simply place the function switch to the COLD position. The

compressor controller has been factory set and no temperature

adjustment should be necessary. If the cold pan is to be used

with ice, it is recommended that the optional perforated bottoms

be used. These will allow ice to melt properly.

Switching from hot to cold operation

Follow this procedure:

1. Place the function switch in the OFF position

and drain out hot water.

2. Allow the unit to cool until it can be safely

cleaned.

3. When clean up procedures are complete, unit

will be ready for cold operation. This takes

about one hour.

To assure maximum compressor life, do not

switch from “hot” to “cold” operation without

allowing a cool down period. Never switch from

hot to cold operation while hot water remains in

the pans. Failure to observe this warning will

greatly reduce compressor life and eventually

cause premature compressor failure.

Switching from cold to hot operation

No special procedure is required to switch from the cold to hot

operation. Be certain to ﬁll will with a minimum of 4” of water.

The unit is designed so that the compressor

and the heating elements cannot operate at

the same time. Continued operation of the

compressor in the “hot position” should not

be considered normal. Call for service if this

happens.

The unit must be turned off when not in use or overnight for

defrosting and cleaning.

Operation N8600 Hot/Cold Series

DA RNGE

T PE

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Komentarze do niniejszej Instrukcji

Brak uwag

Delfield 8100-EF Dokumentacja Strona 13

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Delfield 8100-EF